Owner's manual

5
348002K/348012K Cool-Tech Recovery/Recycling/Recharging Unit
Set Up Instructions
Set-Up Instructions
IMPORTANT!
Be sure the
pump is
running when
adding oil.
IMPORTANT!
For maximum
performance, be
sure to change
the vacuum
pump oil
frequently.
1. Press VACUUM to get to the VACUUM mode. Press START to go into
VACUUM.
NOTE: The vacuum pump is shipped without oil in the reservoir. Before
starting the pump, oil must be added to the pump or damage may occur.
2. Close all manifold valves on the control panel.
3. Remove bolts holding the door closed and open the door.
4. Remove the black plastic plug from the fill port on the top of the vacuum
pump.
5. Attach the oil fill tube to the 16 oz. bottle of vacuum pump oil provided in the
accessory kit.
6. While the vacuum pump is running, add oil until it reaches the center of the
sight glass. Press STOP. The vacuum pump is now filled to the proper level
with oil.
7. Pour oil (approximately 12 oz.) into the fill port of the vacuum pump until the
oil appears at the bottom of the sight glass. Press ENTER.
8. Replace the plug in the fill port.
9. Press STOP to exit.
10. Close the door and replace the bolts holding the door shut.
INSTALLATION ROUTINE
1. Press MENU. Use the ARROW keys to go to the INSTALLATION
ROUTINE.
2. Press ENTER. The display toggles between CONNECT LS RXX HOSE TO
SOURCE TANK and TURN ALL VALVES TO VACUUM/RECOVER
AND PRESS START TO BEGIN. Follow the on-screen prompts.
3. Remove the service hoses from the accessory kit and remove
the plugs from the hoses using a pair of pliers.
4. Attach the service hoses to the high and low side bulkheads on the rear of the
unit. Attach the R-134a hoses to the left rear. Attach the R-12 hoses to the
right rear. Attach the RED hoses to the bulkheads labeled HIGH and the
BLUE hoses to the bulkheads labeled LOW.
VACUUM PUMP INITIAL FILL
1
3
2
INST0760
1. Oil Fill Port
2. Sight Glass
3. Oil Drain