Specifications

The VacuMaster

vacuum pump is shipped without oil in the reservoir. Before

starting the unit, you must fill the pump with oil. Two 16-ounce (472 milliliters)

bottles of oil are included with your unit.

9.Remove the door access screws from the right side of the unit. Open the door.

10. Remove the black plastic plug from the pump’s oil fill port. Attach the flexible spout

and cap to the bottle of oil included with your unit. This makes it easier to fill the

pump.

11. Add one-half of a bottle of vacuum pump oil to the vacuum pump.

12. Press SHIFT/RESET and ENTER at the same time, then press “1.” The vacuum

pump will start and run continuously. While the pump is running, pour oil into the

pump’s oil fill port until the level of oil is even with the line of the pump reservoir

sight glass. Replace the black plug on the oil fill port.

13. Let the pump run for about five (5) minutes to remove any air from the unit.

14. To turn off the pump, press HOLD/CONT. Then press SHIFT/RESET to exit

the diagnostics mode.

15. Connect the blue 96" Hose the the low side port, and the red 96" hose to the high

side port on the back of the unit.

Diagram of Vacuum Pump Components

Oil Filler Tube

Inlet

Pump

Exhaust

Oil Fill Port

Sight Glass

Oil Drain

Fitting

Important!

Be sure the pump

is running when

adding oil. Do not

overfill the pump.

The approximate

oil charge is 13

oz. (384 millili-

ters).

Set Up Instructions