Specifications

Installing the Knobs
Step 1 – Rotate the shafts of the controls on the front of amp fully counter clockwise
Step 2 – with a small screwdriver, loosen the set screw of the first knob
Step 3 – Place this knob on to the first control shaft.
Step 4 – Align the pointer of the knob to the “1” position printed on the chassis.
Step 5 – firmly tighten the set screw of the knob to the shaft.
Step 6 – Repeat for remaining knobs and shafts.
Installing the Chassis Mounting Bolts and Chassis
Step 1 – Press the two truss bolts into the cabinet holes (if not already installed).
Step 2 – Place the amp on the floor onto it's front with the speaker magnet facing up.
Step 3 – Mount the chassis onto the truss bolts, sliding the chassis against the cabinet top.
Step 4 – Install the two #10 KEPS nuts, one on each bolt, and finger tighten the chassis
against top of cabinet.
Step 5 – Pick the face of the amp off of the floor and stand amp up right.
Step 6 – With the nuts on loosely, slide the chassis to the rear of cabinet, away from speaker.
Step 7 – Press back panel into position, pushing the chassis against the panel. This will
properly align the chassis with in the cabinet and provide good contact with the shielding foil.
Step 8 – Place the back panel to the side and firmly
tighten chassis into the cabinet. Do not install back panel
just yet.
Proceed to 7.2
Installing AC Power Cord Clamp
Step 1 – Properly align the 5/16” nylon cable clamp around
power cord (photo 7.2a).
Step 2 – With a #8 x 5/8” screw, secure the cable clamp
and power cord to the inside cabinet wall. (photo 7.2b).
Proceed to Chapter 8
Proper alignment of chassis within cabinet is
when the chassis contacts the back panel
shielding tape without distorting the back panel.
NOTE
7.1
7.3
7
Final Assembly
28 TubeDepot.com
7.2
photo 7.2a
photo 7.2b