Specifications

coming from pad “p”.
Step 14 – Twist these two wires tightly together and route the
wires along the bottom edge of the chassis.
Step 15 – Solder the wire from pad “p” (the one with the mark) to
pin 6 of the octal socket nearest the rectifier tube socket.
Step 16 – Solder the wire from pad “q” to pin 6 of the octal socket
nearest the preamp tube socket.
Step 17 – Neatly organize all wires against the chassis.
Proceed to 6.21
Wiring the feedback wire to speaker output jacks
Step 1 – Strip and tin the end of the yellow wire from
pad “t”.
Step 2 – Connect this wire to the point where the two
speaker output jack tabs are joined (photo 6.21a) and
solder in place.
Proceed to 6.22
Wiring the V2 Preamp Tube
Step 1 - Trim, strip and tin the yellow wire from pad
“m”. Solder this wire to pin 7 of the preamp tube socket
V2 (photo 6.22a).
Step 2 - Trim, strip and tin the yellow wire from pad “n”. Solder this wire to pin 8 of the preamp
tube socket V2 (photo 6.22a).
Step 3 - Trim, strip and tin the yellow wire from pad “r”. Solder this wire to pin 6 of the preamp
tube socket V2 (photo 6.22a).
Step 4 - Trim, strip and tin the yellow wire from pad “s”. Solder this wire to pin 1 of the preamp
tube socket V2 (photo 6.22a).
Step 5 - Trim, strip and tin the red wire routed from the tone control behind the PC board
coming out between V2 and the speaker jack. Solder this wire to pin 2 of the preamp tube
socket V2 (photo 6.22a).
Step 6 - Trim, strip and tin the yellow wire from pad “u”. Solder this wire to pin 3 of the preamp
tube socket V2 (photo 6.22a).
Step 7 – Neatly organize wires against the chassis.
Proceed to 6.23
Wiring the V1 Preamp Tube
Step 1 – Solder a short piece of buss wire between
pins 8 and 3 of V1 (photo 6.23a). Tack this wire in place
at pin 3 for now.
Step 2 - Trim, strip and tin the yellow wire from pad “v”.
Solder this wire to pin 6 of the preamp tube socket V1
(photo 6.23a ).
Step 3 - Trim, strip and tin the yellow wire from pad “w”.
Solder this wire to pin 1 of the preamp tube socket V1 (photo 6.23a ).
Step 4 - Trim, strip and tin the red wire from pad “x”. Solder this wire to pin 7 of the preamp
tube socket V1 (photo 6.23a ).
6.22
22 TubeDepot.com
6.23
photo 6.23a
6.21
photo 6.21a
photo 6.22a