Specifications

http://www.ppwatt.com
Tweed 5E3 PCB Valve Junior Conversion
Build Manual v3.0 13 Feb 2011
35 of 40
7KHWZRUHGZLUHVIURPWKH37JRWRWKH+7SDGV77,WUHDOO\GRHVQ¶W
PDWWHUZKLFK:HGRQ¶WXVHQHJDWLYHIHHGEDFNLQWKLVFLUFXLW
If you are using the stock VJr power switch just solder a jumper between the
standby pads, T3 & T4. If you are using a Stand By switch, wire a pair of
connecting leads as shown.
When wiring the main power switch, remember that the main Active & Neutral
ZLUHVJRWRWKHµFHQWHUSRVWV¶on the switch, and the wires to the PT go from the
µRXWVLGH¶OXJV8VHWKHDSSURSULDWH37ZLUHVIRU\RXUFRXQWULHVYROWDJHV7KH
U.S. would use the 115v taps, yellow & black. Australia & most of Europe would
use the 240v taps, Brown & Black or 230v taps, Blue & Black)
Fasten the ground wires from the Tweed 5E3 PCB and the output transformer to
the star ground screw post.