Specifications

http://www.ppwatt.com
Tweed 5E3 PCB Valve Junior Conversion
Build Manual v3.0 13 Feb 2011
34 of 40
8.1.3 The Power Supply connections
So close now !
We now need to connect the heater & main HT power to the PCB. These wires
DUHVROGHUHGGLUHFWO\WRWKH3&%1RµTXLFNFRQQHFWV¶IRUWKHVH
Again, neatness is important. If cleanliness is next to godliness, neatness is next
DJDLQ:HZDQWWKHVHµQRLV\¶ZLUHVZHOOWZLVWHGURXWHGZHOODZD\IURPWKH
circuitry.
$SLFWXUHSDLQWVDWKRXVDQGZRUGV«
The orange wires from the PT go to the heater pads. I route them from
underneath & up, soldering from the top side of the PCB. The thin wires you can
see soldered to these same pads go to the 6v Bezel. If you have a 120/240v
ODPS\RX¶GWDNHVRPHWDSVIURPWKHSRZHUVZLWFK
If you are using a stock 9-USRZHUVZLWFK\RXZRQ¶WERWKHUZLWKHLWKHURSWLRQ