Specifications

http://www.ppwatt.com
Tweed 5E3 PCB Valve Junior Conversion
Build Manual v3.0 13 Feb 2011
31 of 40
Repeat the process with the Input Jack
complex. The two Instrument channel
wires & ground are short & connect at the
front of the PCB. The two Mic channel
wires are longer, and connect at the back.
Same principle applies though. Keep the
wires as short as possible ± but not too
short ;-<RXUHDOO\GRQ¶WZDQWWRUHGRRQH
RIWKHIO\LQJOHDGVEHFDXVH\RXFXWLWó´
too short !
Take the PCB, control pots & input jack
back out of the chassis & solder them
together.
It should look like WKHSLFWXUHDERYHZKHQ\RX¶UHGRQH
:H¶UHDOPRVWWKHUHQRZ«-XVWWKHSRZHUOHDGVVZLWFKHVWRJR«
Guide the PCB, Pots & Jacks back in & loosely fit them. They¶OOEHFRPLQJEDFN
out after this last lot of measuring & wire cutting.