Specifications

http://www.ppwatt.com
Tweed 5E3 PCB Valve Junior Conversion
Build Manual v3.0 13 Feb 2011
30 of 40
The populated PCB is now ready to be placed in the chassis so that the leads
can be cut to their correct length & soldered to the PCB.
8. Putting it all together
8.1 Install the New Components
1RZWKDWHYHU\WKLQJLVRXWRIWKHFKDVVLVWKDWZHGRQ¶WQHHGWKHFKDVVLVKDV
been drilled, and the Tweed 5E3 PCB has been assembled, we can prep the
chassis and install all of the new components.
8.1.1 Hookup the Tweed 5E3 PCB
Place the circuit board into the chassis, align the mounting standoffs to their
respective chassis holes and lightly fasten the board to the chassis with a screw.
:H¶OOEHtaking it back out to solder the connecting wires)
Mount the pots inside the chassis as shown: -
Guide the wires from the pots to their respective solder pads on the PCB. Trim
the wires to length ± not too short, nor too long. You want them to end up nice &
neat.