Specifications

http://www.ppwatt.com
Tweed 5E3 PCB Valve Junior Conversion
Build Manual v3.0 13 Feb 2011
12 of 40
5.2.4 Remove the Volume Potentiometer
Unscrew the fastening nut from the volume
potentiometer.
Pull the volume pot back into the chassis. Leave it
connected to the stock EVJ circuit board.
The volume pot will be glued to the
chassis. This part will NOT be used later
in the build, so use whatever force you
need.
5.2.5 Remove the Stock EVJ Circuit Board
Disconnect these four (4) leads from
the stock EVJ circuit board.
Lift the ground wire from the star
ground post.
Unplug the input jack wire at the circuit
board.
Remove the six (6) screws fastening
the circuit board to the chassis.
.HHSWKHP<RX¶OOXVHWKHPWRDWWDFK
the new PCB.