10-737 3/11/04 8:15 AM Page 1 9615 ® INTEGRATED COMFORT SOLUTIONS™ DIGITAL PROGRAMMABLE THERMOSTAT E G ELECTRIC GAS 7 Day Programmable 2 Heat / 2 Cool User’s Manual Quick Start Installation and Programming WA 110-737 As an Energy Star partner, Maple Chase has determined that this thermostat product meets the Energy Star guidelines for energy efficiency.
110-737 3/11/04 8:15 AM Page 2 Features • Four pre-programmed Energy Star setpoints for each day of the week • Quickset™ programming for quickly programming all days of the week simultaneously • Energy Efficient Recovery (EER™) • Residual cooling for added air-conditioning efficiency • Two “AA” ENERGIZER brand batteries retain program memory, even during power outages • Low battery indicator • LED indicator for auxiliary system operation • Zone compatible as master thermostat • Fahrenheit/Celsius displa
110-737 3/11/04 8:15 AM Page 3 FIGURE 1 Installing Item 9615 Thermostat NOTE: FOR NEW INSTALLATIONS, MOUNT THERMOSTAT ON INSIDE WALL, 4-5 FEET ABOVE THE FLOOR. DO NOT INSTALL BEHIND A DOOR, IN A CORNER, NEAR AIR VENTS, IN DIRECT SUNLIGHT, OR NEAR ANY HEAT OR STEAM GENERATING FIXTURES. INSTALLATION AT THESE PLACES WILL AFFECT THERMOSTAT OPERATION. IMPORTANT: THIS THERMOSTAT IS COMPATIBLE WITH 100% LOCKOUT SYSTEMS. TO RESET THE SYSTEM, TURN THERMOSTAT TO OFF POSITION FOR AT LEAST 60 SECONDS. 1.
110-737 3/11/04 8:15 AM Page 4 FIGURE 3 MOUNTING HOLES C PROG MAN MORN DAY EVE NITE EER CHANGE SET R Y2 Y1 W1 W2 AM PM G PROG/MAN O B COOL OFF HEAT FAN AUTO ON 7. Drill the marked holes using a 3/16" drill bit. NOTE: Enclosed plastic anchors do not require a drilled hole for drywall. 8. Tap plastic anchors into the holes. 9. Align base with plastic anchors and feed wires through opening. See Fig 4.
110-737 3/11/04 8:15 AM Page 5 Programming Guide Set Time of Day, Day of Week, Temperature Differential, Residual Cooling 1. Press SET & PROG/MAN. Release simultaneously. SET PROG/MAN PROG MAN AUTO - ON > COOL-OFF-HEAT > > > AUX SET PROG/MAN > > Press or Time of Day. to change > Press > 2. Press SET P 1=MO 2=TU 3=WE 4=TH 5=FR 6=SA 7=SU To Change Day of Week Press > SET P > 3.
3/11/04 8:15 AM Press > 5. Press Page 6 > 110-737 SET P To change Residual Cooling NOTE: THE RESIDUAL COOL FEATURE WILL KEEP THE SYSTEM FAN ON FOR AN ADDITIONAL 30, 60 OR 90 SECONDS AFTER THE COMPRESSOR CYCLES OFF. THE RESIDUAL COOL FEATURE CAN ONLY BE SET IN THE COOL MODE. Changing Fahrenheit (F) to Celsius (C) Press > Press and Hold SET SET P Release both simultaneously. QuickSet™ Programming Mode COOL-OFF-HEAT PROG MAN > > AUX SET PROG/MAN COOL-OFF-HEAT AUTO - ON SET P > > 1.
110-737 3/11/04 8:15 AM Page 7 4. Press SET. SET PR PROG MAN AUTO - ON > COOL-OFF-HEAT > > > > > AUX SET PROG/MAN 5. Press or to change MORN temperature. 6. Repeat Steps 2-5 for DAY, EVE, and NITE. 7. Repeat steps 2–6 above to program any other day of the week. COOL-OFF-HEAT 8. Shift COOL-OFF-HEAT to HEAT position. 9. Repeat steps 2-6 to program HEAT (winter) settings. Begin Programmed Operation 1. Place AUTO/ON into AUTO.
110-737 3/11/04 8:15 AM Page 8 Energy Efficient Recovery EER™ EER™ allows your system to operate at peak efficiency for optimal energy savings. EER™ looks up to 2 hours prior to the end of a set-back period to begin monitoring system performance and determine the most efficient time to turn on your system. During this period, the auxiliary stages of heating or cooling will be locked out. Only the most efficient stages will be utilized.
110-737 3/11/04 8:15 AM Page 9 To Test Thermostat WARNING: DO NOT SHORT (JUMPER) ACROSS TERMINALS OF GAS VALVE OR SYSTEM CONTROL TO TEST OPERATION. THIS WILL DAMAGE THE THERMOSTAT AND VOID YOUR WARRANTY. CAUTION: DO NOT SWITCH SYSTEM TO COOL IF THE TEMPERATURE IS BELOW 50°F (10°C). THIS CAN DAMAGE THE AIR CONDITIONING SYSTEM AND CAUSE PERSONAL INJURY. 1. Place the COOL-OFF-HEAT switch into the COOL position. COOL-OFF-HEAT > 2.
110-737 3/11/04 8:15 AM Page 10 Troubleshooting SYMPTOM REMEDY Thermostat does not turn on system. Check Wiring. (See “INSTALLATION.”) Check fuse. Replace with 3 amp fuse if fuse has opened. Five minute compressor short cycle protection may be in effect. Press RESET to override. NOTE: This will erase programming. Thermostat turns on and off too frequently. Increase Temperature Differential (See “PROGRAMMING.”) Display is blank, flashing or constant "LO BAT". Replace batteries.
0-737 3/11/04 8:15 AM Page 11 Wiring Diagrams The following is just a sample of the most common types of HVAC systems. Refer to your system’s installation manual for wiring information.
110-737 3/11/04 8:15 AM Page 12 Five-Year Limited Warranty Maple Chase Company warrants to the original contractor installer, or to the original consumer user, each new Robertshaw thermostat to be free from defects in materials and workmanship under normal use and service for a period of five (5) years from date of purchase.
