Owner's Manual

CYCL = Cycle Timer allows a compressor to rest between cycles. Can be

set from 0 to 5 minutes in 1 min increments.

WARNING: A wrong short cycle setting can

damage your equipment. This should only

be changed by a trained HVAC professional.

CAL = Calibration offset. Changes the displayed temperature from the

actual temperature by +3 to -3 degrees in one degree increments.

Increasing the offset by +2 will cause the thermostat to display

a temperature that is 2 degrees higher than the actual room

temperature

Creating a Password – Protect the Settings

The buttons on the front of the thermostat can be locked with a password.

To create a password:

1. Press the

and buttons at the same time and hold them in for

5 seconds.

You will be asked for a 4 digit password.

2. Each digit is set using the

and buttons. Press the to

move to the next digit and to save the password after the 4th digit is

entered. Press to move back.

3. The password is saved after 5 seconds.

All of the front buttons are now locked out until the password is entered.

Pressing any button will cause to flash.

To unlock the buttons:

1. Push and hold the and buttons for 5 seconds until the

request for password is displayed.

2. Enter the digits for the password by pressing the and

buttons. Press the

to move to the next digit and to save the

password after the 4th digit is entered. Press to move back.

3. When the correct password is set, wait for 5 seconds to unlock

the system.

4. If the wrong password is entered the display will flash ---- for 5

seconds then return to normal.

Once the security has been disabled, a password needs to be recreated

to protect the settings.