Specifications

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

Operating your clock radio - DAB

1. Fully extend the wire aerial located on the rear of your clock radio.

Place the wire antenna so that it is as straight as possible extending

either above or below the clock radio.

2. Press the On / Off button to switch on your clock radio. When ﬁ rst

switched on, the clock radio will be in DAB mode. After each use the

clock radio will remember the mode used and then switch on in that

mode the next time it is used.

3. If this is the ﬁ rst time the clock radio is used a quick scan of the Band

III DAB channels may be carried out (the scan is normally performed

automatically when the clock is ﬁ rst set - page 5). If the clock radio has

been used before, the last used station will be selected. If new radio

stations are found, they will be added to the stored list of stations.

4. When the scan is completed the ﬁ rst station (in numeric-alpha order

0....9, A....Z will be selected. The ﬁ rst station in the list of stations found

during scanning will be played. The display will show the station name

in the ﬁ rst line of the display and other information in the second line.

5. If the station list is still empty after the scan operation your clock radio

will display 'No stations available'.

6. If no signals are found it may be necessary to relocate your clock radio

to a position giving better reception, and then repeat the scan using

the auto scan facility (page 9).