Specifications

13
Operating your radio - FM
1. Carefully extend the telescopic aerial.
2. Press the On/Off button to switch on your radio.
3. Press the Band button to select the FM band.
4. Press and release the Auto Tune button. Your radio will scan in
an upwards direction (low frequency to high frequency) and stop
automatically when it fi nds a station of suffi cient strength.
5. After a few seconds the display will update the display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
6. Press and hold the Auto Tune button for 2 seconds to scan the FM
band in a downwards direction (high frequency to low frequency).
7. When the waveband end is reached your radio will recommence tuning
from the opposite waveband end.
8. Adjust the Volume and Tone controls to the required setting.
9. To switch off your radio press the On/Off button.
The use of radio station presets for selecting your preferred radio
stations is described on page 18.
2,9
3
4,6
8
8