ROBERTS CR9901 Sound for Generations 3 Band Single Alarm Clock Radio CR9901 Instruction Book.
Controls FM O ff B u z z A u to O n 5 M W LW 4 V o lu m e 3 (Top) 2 H our M in u te A la rm /O ff S le e p Low D im m e r H ig h 6 1 T u n in g T im e CR 9901 3 B a n d C lo c k R a d io 12 (Left side) 11 10 9 8 7 1. Dimmer switch 5. Waveband selector 2. Function switch 6. Tuning control 10. Minute button 3. Headphone socket 7. Sleep button 11. Hour button 4. Volume control 8. Snooze button 12. Time button 9. Alarm/Off button 1 CR9901 Instruction Book.
Controls (Front) 15 16 150 LW 17 0 210 240 260 kH z PM 18 M W 540 600 800 FM 88 92 96 10 0 0 10 0 13 0 0 10 4 16 0 0 kH z 10 8 M H z 10 6 17 15. PM indicator 16. LED dial pointer 17. Battery compartment (underside) 18. Alarm indicator If you need any further advice, please call our Technical Helpline on :2 0181 758 0338 (Mon-Fri) CR9901 Instruction Book.
Switching on and setting the time Before using your clock radio you must first set the correct time. ON 1. Place the unit on a flat surface. Plug the power cord into the wall socket and switch on. 15 0 LW 17 0 21 0 24 0 26 0 M W 54 0 60 0 80 0 FM 88 92 96 10 0 0 10 0 130 0 10 4 10 6 2. The clock display will flash 12.00. P M 3. Press and hold down the Time Set button. 4. Whilst holding down the Time Set button press the Hour, or Minute buttons to set the time.
Listening to the Radio 1. Turn on the radio by sliding the Function switch to the 'On' position. The LED dial pointer will light up indicating that the radio is switched on. O ff B u z z A u to O n 150 LW 170 210 M W 540 600 800 FM 88 92 96 240 10 0 0 10 0 260 13 0 0 10 4 kH z 16 0 0 kH z 10 6 10 8 M Hz 240 260 2. Select the required waveband using the Waveband selector switch. FM M W 3. Tune in to the desired station by rotating the Tuning control.
Alarm The alarm can be set to wake you by either the buzzer or the radio. A la r m / O ff Setting alarm time 1. Press and hold down the Alarm/Off button. T im e 2. Whilst holding down theAlarm/Off button press the Hour, or Minute buttons to set the time. Release the buttons when the correct alarm time is reached. The clock uses a 12 hour display with aPM indicator. Ensure that the correct 12 hour cycle is selected. P M A la rm / O ff Checking the alarm time 1.
Setting the alarm to wake to buzzer O ff B u z z A u to O n 1. Set the alarm time as previously described. Set the Function switch to the 'Buzz' position. The Alarm indicator will light. The alarm will sound every day at the preset time for 59 minutes. To turn off the alarm until the next day press the Alarm/Off button. To turn off the alarms permanently set the Function selector to the 'Off' position. P M Setting the alarms to wake to radio 1. Set the alarm time as previously described.
Snooze control A la r m / O ff The radio or buzzer alarm can be silenced for 7 minutes by pressing the Snooze button. This sequence can be repeated whilst the alarm is sounding. Sleep timer A la r m / O ff The radio can be set to turn off after a preset time has elapsed. Press and hold down the Sleep button until the desired time is reached (maximum 59 minutes in 1 minute steps). The radio will switch off after the sleep time has elapsed.
General Fuse Do not allow this unit to be exposed to water or steam. It is recommended that the FM band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on the MW or LW bands. This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug (BS1363). If another type of plug is used a 5A fuse should be fitted in the plug, adaptor or distribution board. IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN. Mains supply only.
Specifications Circuit Features Power Requirements Mains AC 230 volts, 50Hz Back-up Battery IEC size 6LR61 (6F22, PP3) Frequency Coverage FM 87.5 - 108MHz MW 525 - 1610kHz LW 147- 284kHz Loudspeaker 75mm diameter 8 ohms Output Power 0.3W RMS Aerial System FM Wire Aerial MW Built-in Ferrite aerial LW Built-in Ferrite aerial only ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice.
Notes: If you need any further advice, please call our Technical Helpline on :0181 758 0338 (Mon-Fri) CR9901 Instruction Book.
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers.
