ROBERTS CR987 Sound for Generations 3 Band Dual Alarm Clock Radio CR987 Instruction Book.
Controls 11 (Top) (Front) 1 2 3 4 5 1 Auto Dimmer 10 2 PM CR 987 FM 88 92 MW 530 LW 96 100 104 106 600 700 150 170 108 MHz 1000 1300 1600 kHz 200 230 260 280 6 7 2 3 4 5 6 7 8 9 S. Fwd Alarm 13 14 Radio On 10 Off Radio/Alar m/Sle ep 16 S noo ze Sleep 15 1. Auto dimmer 8. Slow reverse button 13. Alarm set button 2. Alarm 1 indicator 9. Slow forward button 14. Snooze button 3. Alarm 2 indicator 10. Fast forward button 15. Sleep button 4.
Controls (Right side) (Left side) 18 20 21 22 Radio 1 Off T u n in g Radio FM M W LW V o lu m e 2 O ff 19 23 18. Alarm 1 function selector switch 20. Tuning control 19. Alarm 2 function selector switch 21. Waveband selector switch 22. Volume control 23. Battery compartment (underside) If you need any further advice, please call our Technical Helpline on :2 0181 758 0338 (Mon-Fri) CR987 Instruction Book.
Switching on and setting the time Before using your clock radio you must first set the correct time. ON 1. Place the unit on a flat surface. Plug the power cord into the wall socket and switch on. 1 Aut o Dim mer 2 PM FM 88 MW 530 92 96 100 104 106 600 700 150 170 LW 108 MH z 1000 1300 1600 kHz 200 230 260 280 kHz S ca le 0 S ca le 1 2 3 4 5 6 7 8 9 10 2. The clock display will flash 12.00. 1 2 PM Time 3. Press and hold down the Time Set button.
Listening to the Radio 1. Turn on the radio by pressing the Radio On button. The LED dial pointer will light up indicating that the radio is switched on. FM 88 MW 530 LW Radio O n 92 96 100 600 150 700 170 104 106 108 1000 1600 1300 200 230 260 MHz kHz 280 kHz Scale O ff R adio/ Ala Sleep Scale 0 r m/Sleep 1 2 3 4 5 6 7 8 9 10 2. Select the required waveband using the Waveband selector switch. T uni ng FM M W LW 3.
Setting alarm times The alarms can be set to wake you by either the buzzer or the radio. Your alarm clock radio has 2 separate alarms which can be set to activate at different times. Setting alarm 1 Radio 1. Slide the Alarm 1 function switch to the Radio or 1 position. 1 Off 2. Press and hold down the Alarm set button. Time Se t Alarm S noo ze S. Rev 3.
3. Whilst holding down the Alarm Set button press the fast forward (FFwd), slow forward (S-Fwd) or slow reverse (S-Rev) buttons to set the required alarm time. Release the buttons when the correct alarm time is reached. The clock uses a 12 hour display with a PM indicator. Ensure that the correct 12 hour cycle is selected. S. Rev S. Fwd F. Fwd Checking the Alarm Times 1.
Setting the alarms to wake to buzzer 1. Set the alarm time as previously described. Set the Alarm 1 or Alarm 2 function selector to the position. The corresponding Alarm 1 or Alarm 2 indicator will light. Radio The alarm will sound every day at the preset time for 59 minutes. To turn off the alarm until the next day press the Radio/Alarm/Sleep Off button. To turn off the alarms permanently set the Alarm 1 or Alarm 2 function selector to the 'Off' position.
Snooze control Time The radio or buzzer alarm can be silenced for 6-7 minutes by pressing the Snooze button . This sequence can be repeated whilst the alarm is sounding. Set Alarm Sno oze Sleep timer S. Rev S. Fwd F. Fwd The radio can be set to turn off after a preset time has elapsed. 1 Press and hold down the Sleep button until the desired time is reached (maximum 59 minutes in 1 minute steps). The radio will switch off after the sleep time has elapsed.
General Fuse Do not allow this unit to be exposed to water or steam. It is recommended that the FM band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on the MW or LW bands. This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug (BS1363). If another type of plug is used a 5A fuse should be fitted in the plug, adaptor or distribution board. IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.
Specifications Circuit Features Power Requirements Mains AC 230 volts, 50Hz Back-up Battery IEC size 6F22 (6LR61, PP3) Frequency Coverage FM 87.5 - 108MHz MW 525 - 1610kHz LW 147- 284kHz Loudspeaker 75mm diameter 8 ohms Output Power 0.3W RMS Aerial System FM Wire Aerial MW Built-in Ferrite aerial LW Built-in Ferrite aerial only ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice.
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers.
