Specification

ManualsBrandsRoberts ManualsAdhesivesQuick Bond 12 oz. Spray Adhesive

Safety Data Sheet

Revision Date: 04/05/2017

SECTION 1: Identification and Company Details

Product Name: 8200 Quick Bond Spray Adhesive

Product Code: 8200

Manufacturer/ Supplier: Roberts Consolidated Industries, Inc.

Address: 300 Cross Plains Blvd.

Dalton, GA 30721

Emergency Phone: (800) 424-9300 (24-hour Response / CHEMTREC)

Product Information: (706) 277-5294

SECTION 2: Hazard(s) Identification

OSHA / HCS Status: This material is considered hazardous by the OSHA Hazard.

Communication Standard (29 CFR 1910.1200)

Physical hazards: Flammable aerosols Category 1

Health Hazards Skin corrosion/irritation Category 2

Serious eye damage/eye irritation Category 2A

Reproductive toxicity (fertility) Category 2

Specific target organ toxicity, single exposure Category 3 narcotic effect

Specific target organ toxicity, repeated exposure Category 2

Aspiration hazard Category 1

Signal Word: Danger

Hazard Statements: Extremely flammable aerosol

May be fatal if swallowed and enters airways

Causes skin irritation

Causes serious eye irritation

May cause drowsiness or dizziness

Suspected of damaging fertility

May cause damage to organs through prolonged or repeated exposure

Hazard Pictograms:

Precautionary Statements: Obtain special instructions before use. Do not handle until all safety precautions have been read and

understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open

flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Do not breathe

gas. Use only outdoors or in a well-ventilated area. Wear protective gloves/protective clothing/eye

protection/face protection.

SECTION 3: Composition / Information on Ingredients

Weight % CAS #

Acetone 20 – 40 67-64-1

Propane 20 – 40 74-98-6

Dimethyl Ether 10 - 20 115-10-6

n-Hexane 10 - 20 110-54-3

2-Methylpentane 2.5 – 10 107-83-5

3-Methylpentane 1 - 2.5 96-14-0

Other components below reportable levels 10 - 20

Summary of content (8 pages)

PAGE 1
Safety Data Sheet SECTION 1: Product Name: Product Code: Manufacturer/ Supplier: Address: Emergency Phone: Product Information: SECTION 2: Revision Date: 04/05/2017 Identification and Company Details 8200 Quick Bond Spray Adhesive 8200 Roberts Consolidated Industries, Inc. 300 Cross Plains Blvd.
PAGE 2
SECTION 4: First-Aid Measures Inhalation: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or doctor/physician if you feel unwell. Wash off with soap and water. Get medical attention if irritation develops and persists. Rinse with water. Get medical attention if irritation develops and persists. Rinse mouth. Get medical attention if symptoms occur.
PAGE 3
SECTION 7: Handling and Storage Precautions for Safe Handling: Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Pressurized container: Do not pierce or burn, even after use. Do not use if spray button is missing or defective. Do not spray on a naked flame or any other incandescent material. Do not smoke while using or until sprayed surface is thoroughly dry.
PAGE 4
US. Workplace Environmental Exposure Level (WEEL) Guides Components Type Dimethyl Ether (CAS 115-10-6) TWA BIOLOGICAL LIMIT VALUES: ACGIH Biological Exposure Indices Components Value Determinant Acetone (CAS 67-64-1) 50 mg/l Acetone n-Hexane (CAS 110-54- 0.4 mg/l 2,5-Hexanedion, 3) without hydrolysi * - For sampling details, please see the source document.
PAGE 5
SECTION 10: STABILITY AND REACTIVITY Reactivity: The product is stable and non-reactive under normal conditions of use, storage and transport. Material is stable under normal conditions. Hazardous polymerization does not occur. Avoid temperatures exceeding the flash point. Contact with incompatible materials. Strong oxidizing agents. No hazardous decomposition products are known.
PAGE 6
Persistence and Degradability: Bioaccumulative Potential: No data is available on the degradability of this product. No data available. Partition Coefficient n-octanol / water (log Kow): 2-Methylpentane 3.74 3-Methylpentane 3.6 Acetone -0.24 Dimethyl Ether 0.1 nHexane 3.9 Propane 2.36 No data available. Mobility in Soil: No other adverse environmental effects (e.g.
PAGE 7
SECTION 15: REGULATORY INFORMATION US federal regulations: This product is a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR 1910.1200. All components are on the U.S. EPA TSCA Inventory List. TSCA Section 12(b) Export Notification (40 CFR 707, Subpt. D): CERCLA Hazardous Substance List (40 CFR 302.4): Not regulated. Acetone (CAS 67-64-1) Listed. n-Hexane (CAS 110-54-3) Listed. SARA 304 Emergency Release Notification: Not regulated.
PAGE 8
SECTION 16: Other Information This Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Hazardous Products Regulation (WHMIS 2015) Prepared by: Roberts Product Safety & Regulatory Compliance Group, (905) 791-4444 The information herein is given in good faith, but no warranty expressed or implied is made.