Sound for Generations ROBERTS R9994 LW/MW/FM STEREO 3-BAND RADIO Operating Instructions
Controls 3 4 5 1 7 6 8 2 9 1 1. Volume control 5. Tuning control 2. Waveband switch 6. Tuning indicator 3. Earphone socket 7. Stereo indicator 4. Speaker/on/off switch 8. Tuning scale 9.
Controls cont. 11 10 10. MW/LW switch 12 11. Belt clip 12.
Battery To insert the batteries first open the battery cover (12) by sliding it in the direction shown by the arrow. Insert two LR03 ( AAA) size batteries into the compartment. Ensure that batteries are inserted in accordance with the diagrams shown inside the battery compartment. • Reduced power, distortion and a ‘stuttering’ sound are all signs that the batteries may need replacing.
2 1 3 If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri) 4
Operating your radio MW/LW 1. Turn on the radio by setting the speaker/on/off switch (4) to the “On” position. 2. For MW and LW reception set the waveband switch (2) to the “MW/LW” position. 3. Select the required MW or LW band by using the MW/LW switch (10). 4. Adjust the volume control (1) to the desired level of sound. Rotating the control anti-clockwise will increase the sound level. 5. Slowly rotate the tuning control (5) until the dial pointer corresponds to the frequency of the desired station.
1 2 4 3 5 6 If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri) 6
Operating your radio FM 1. Turn on the radio by setting the speaker/on/off switch (4) to the “On” position. 2. For FM stereo reception set the waveband switch (2) to the “FM Stereo” position. When a station being received is in stereo the stereo indicator will light. • If the FM signal becomes weak or is accompanied by a high level of background hiss, you may select MONO mode by setting the switch to the “FM” position. 3. Adjust the volume control (1) to the desired level of sound.
1 2 3 4 6 If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri) 8
Belt Clip 1. A belt clip on the rear of your radio is provided to enable your radio to be clipped onto a belt. 1 2. Clip the belt clip to the rear of your radio. General Do not allow this unit to be exposed to water, steam or sand. Do not leave the unit where excessive heat could cause damage such as in a parked car where the heat from the sun can build up even though the outside temperature may not seem too high.
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers.
ROBERTS RADIO TECHNICAL SERVICES DEPARTMENT 97-99 WORTON ROAD ISLEWORTH MIDDLESEX TW7 6EG If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri) Issue1
