Radio User Manual

Dimmer function
The brightness of the display can be adjusted for when the radio is in
Stand-by and for when it is in use. If you use the unit in a bedroom, you
may prefer a lower stand-by brightness level than the standard setting.
The dimmer can be set to low, mid, high and an almost off 'night time'
setting.
1. Press the On/Off button to switch on the radio.
2. Press the Menu button once or twice as needed until "Main Menu"
appears on the display. Rotate the Tuning/Select control until "Set
up" shows on the display.
3. Press and release the Tuning/Select control to enter the Set up menu
and rotate until "Dimmer" appears on the display. Press and release
the Tuning/Select control to enter dimmer setup.
4. To adjust the display brightness when the radio is switched on rotate
the Tuning/Select control until "Active mode" is highlighted on the
display.
To adjust the display brightness when the radio is in stand-by rotate
the Tuning/Select control until "Standby mode" is highlighted.
Press the control to enter the selected brightness adjustment mode.
5. To adjust the brightness level rotate the Tuning/Select control.
6. The backlight level will change as the control is rotated so that you
can see the effect of each setting. Note that the backlight is almost
completely off at zero setting. Press the Tuning/Select control to set
the level.
1
2
2-6
29