Service manual

EP-300 SERIES PUMP INSTALLATION, OPERATION AND SERVICE MANUAL
10
5.3 Mounting Wall Bracket Assembly 5.3.1 Mounting Platform
The standard method of mounting the pump is on an
outside wall and venting directly through the wall.
The pump may be mounted by using mounting
angles as shown in Figure 5 and Figure 6. The two
mounting angles form a mounting platform to which
the pump will be attached.
Fix the mounting frame to the wall using anchors.
Select an anchor that will give equal to or greater
than 2000 lbs ultimate pull-out strength.
FIGURE 5: Wall Bracket Assembly
FIGURE 6: Mounting Platform Options
WARNING
Suspension Hazard
Mount pump with materials
with a minimum working
load of 400 lbs (181 kg).
Failure of the supports can
result in death, injury
or property damage.
Mounting
Angle
Hex Head Bolt
Flat Washer
Lockwasher
Hex Nut
Flat Washer
Description Part Number
Mounting Angle 01365000
Hex Bolt 5/16" x 3/4" 93413912
Flat Washer 95211600
Lockwasher 96411600
Hex Nut 92113900
10 5/8
(27 cm)
8 5/64
(20.5 cm)