Service manual

SECTION 1: HEATING SYSTEM SAFETY
1 of 27
SECTION 1: HEATING SYSTEM SAFETY
Yo ur Safety is Important to Us!
This symbol is used throughout
the manual to notify you of
possible fire, electrical or burn
hazards. Please pay special
attention when reading and follow-
ing the warnings in these sections.
Installation, service and annual inspection of heater
and pump must be done by a contractor qualified in
the installation and service of gas-fired heating
equipment.
Read this manual carefully before installation, opera-
tion or service of this equipment.
This heating system is designed for heating nonresi-
dential indoor spaces. Do not install in residential
spaces. These instructions, the layout drawing, local
codes and ordinances, and applicable standards that
apply to electrical wiring, venting, etc., must be thor-
oughly understood before proceeding with the instal-
lation.
Protective gear is to be worn during installation, oper-
stion and service. Thin sheet metal parts, such as
the variou s venting components, hav
e sharp edges.
To p revent injury, the use of work gloves is recom-
mended.
Do not attempt to operate the pump until all steps of
the installation have been accomplished.
This pump must be applied and operated under the
general concepts of reasonable use and installed
using best building practices.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowl-
edge, unless they have been given supervision or
instruction concerning use of the appliance by a per-
son responsible for their safety. Children should be
supervised to ensure that they do no play with the
appliance.
For additional copies of the Installation, Operation
and Service Manual, please contact Roberts-Gordon
LLC.
1. 1 Ma np owe r Re quirements
To p revent personal injury and damage to the pump,
two persons will be required for installation.
1.2 Safety Labels and Their Placement
Product safety signs or labels should be replaced by
the product user when they are no longer legible.
Please contact Roberts-Gordon LLC or your ROB-
ERTS GORDON
®
independent distributor to obtain
replacement signs or labels. See Page 2, Figure 1.
1.3 California Proposition 65
In accordance with California Proposition 65 require-
ments, a warning label must be placed in a highly
visible location on the outside of the equipment (i.e.,
near equipment’s serial plate). See the heaters’
Installation, Operation and Serv ice Manual for label
placement. Avoid placing label on areas with extreme
heat, cold, corrosive chemicals or other elements. To
order additional labels, please contact Roberts-Gor-
don LLC or your ROBERTS GORDON
®
indepen-
dent distributor.