Infrared Heating System Owner's Manual

ROBERTS GORDON
®
CRV-SERIES SUBMITTAL SHEET
© 2004 Roberts-Gordon
BEFORE INSTALLATIO N AND OPERATI ON OF HEATIN G EQUI PMENT, READ AND UNDERSTAND THE I NSTALLATION, O PERATION AND SERVICE MANUAL.
APPLICATIONS, ENGIN EERING AND DETAI LED GUIDANCE ON SYST EMS DESIGN, INSTALLATION AND PRODUCT PERFORMANCE IS AVAILABLE UPO N REQUEST. ROBERTS GORDON
®
PRODUCTS ARE TO BE
INSTALLED ONLY I N ACCOR DANCE WIT H LOCAL LAW S, CODES AND REGULATIONS, AND ONLY BY A CONTRACTO R QUALIFIED IN THE INST ALLATION AND SERVICE OF GAS-F IRE D HEAT ING EQUIPMEN T.
Reflector Side Extension Installation for Decorative Grilles
ONE-FOOT DECORATIVE GRILLE INSTALLATION
One-Foot Decorative Grille Bracket
Reflector Side Extension
Cut Relief Notches for Tube
and Reflector Hangers
A
NOTE: If the Decorative Grille system is to be installed in an area
with considerable air movement, it is recommended that one
#8 x 3/8 (3.9 x 9.5mm) sheet metal screw be installed per reflector
extension to prevent it from blowing over.
Allow 6" (15 cm)
minimum clearance
between Burner Box
and overhead
obstructions for
service.
6" (15 cm) Minimum
Insert Screw
here
(See NOTE)
Distance "A" E xtension
Minimum Maximum Part No. Width
2" (4 cm) 6" (15 cm) 01370408 8" (20 cm)
6" (15 cm) 10" (26 cm) 01370412 12" (30 cm)
10" (26 cm) 14" (37 cm) 01370416 16" (40 cm)
Description Part Number
Reflector Side Extension 01370412
#8 Sheet Metal Screws
Cut relief notches for
supports and hangers.
Decorative Grille Bracket
2"
Minimum
Bracket
Overlap
Description Part Number
Bracket 01363003
In order to maintain reflector shape, do
not fasten brackets together. Do not
fasten bracket to adjoining reflectors.
Maintain same slipjoint position as
reflectors.