Service manual

COMBAT

UH UNIT HEATER INSTALLATION OPERATION AND SERVICE MANUAL

SECTION 5: MAJOR COMPONENTS

5.1 General

Heaters are designed for installation above 6'

(1.8 m). These heaters must be installed within the

heated space. Duct delivery systems are not

permitted with axial fan units. When handling or

supporting the heater from below, ensure that the

weight is taken at the support points.

5.2 Shelf Mounting and Suspension

For typical suspension, See Page 7, Figure 2.

5.3 Wall Mounting

For typical suspension, See Page 8, Figure 3. Wall

mounted heaters blowing parallel to the wall can

only be installed with the service door away from the

wall.

The wall mounting brackets must be attached to a

suitable wall through all mounting holes. Screw

sizes less than 3/8" may not be used. In order for the

wall mounting brackets to adequately carry the

weight of the heater, it must be installed according to

best building practices.

WARNING

Crush Hazard

Use 3/8" threaded rod

minimum.

Failure of the supports can

result in death, injury

or property damage.