Instructions / Assembly
EC1162C
ASSEMBLY & INSTALLATION INSTRUCTIONS
Components List
Hardware List
F
c
2
Barrel Knobs
A
Item Description Quantity Item Description Quantity
Item Description QuantityItem Description Quantity
Bulb (Not Included)
Glass
Socket Collar
Fixture Body
Screws
3
2
2
B
C
D
E
a
b
Note: (1). The above diagram illustrates the installation of your new light fixture. This is a representative drawing
and may not match the style of your light fixture.
1
1
3
3
3
1. Carefully unpack fixture from the carton. Take the parts out of package and lay all the fixture components in a clean
and flat surface.
2. Attach the Canopy Mounting Screws (a) into the hole of the Mounting Bracket (B) facing outward. Secure the Mounting
Bracket (B) to the outlet box with appropriate sized screws (b) (not included).
Note: The side of mounting plate marked “GND” must face out.
3. Connect the GROUND WIRE from the fixture and canopy to junction box, secure the electrical connections using the
Wire Connector (A). Connect the NEUTRAL (OR WHITE) WIRE from the fixture to NEUTRAL WIRE from power supply
with the Wire Connector (A). Connect the HOT (OR BLACK) WIRE from fixture to HOT WIRE from power supply with the
Wire Connector (A). Tuck wires neatly back into the outlet box.
4. Adjust Mounting Bracket (B) and lock the Fixture Body (C) onto the Canopy Mounting Screws facing outward, then
secure in place with Barrel Knobs (c).
5. Install Glass (D) onto the Fixture Body (C) and tighten the Glass (D) using the Socket Collar (E).
6. Screw Bulb (not included) (F) into the lamp socket. Do not exceed the maximum wattage specified on the fixture
wattage rating label. MAXIMUM 100 Watts.
Wire Connector
Canopy Mounting Screws
Mounting Bracket
C
Outlet box
A
a
b
c
D
B
E
F
ASSEMBLY & INSTALLATION
WARNING
TO AVOID THE RISK OF ELECTRICAL SHOCK, BE SURE TO TURN OFF MAIN POWER PRIOR
TO INSTALLATION.
CAUTION
Refer to the wattage caution label located near the socket for recommended maximum wattage. Do not exceed
maximum wattage.
5017369