User's Instructions

ABN 48 004 315 628
BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Ger
many
Citibank Pty. Ltd., BSB 242
-000 Account No. 201455006 for domestic AUD transactions
Deutsche Bank AG Stuttgart, Swift Code DEUTDESS, Account No. 0165005000 for overseas and foreign currency
transactions
Robert Bosch (Australia)
Pty.
Ltd
Locked Bag 66
Clayton South VIC 3169
Visitor:
1555 Centre Road
Clayton VIC 3168
Tel [phone]
www.bosch.com.au
The device under test is manufactured by the grantee (Robert Bosch
(Australia) Pty Ltd) and sold as an OEM product. Per 47 CFR 2.909, 2.927,
2.931, 2.1033, etc…, the grantee must ensure the end-user has all applicable /
appropriate operating instructions. When end-user instructions are required, as
in the case of this product, the grantee must notify the OEM to notify the end-
user.
Robert Bosch (Australia) Pty Ltd will supply this document to the
reseller/distributor dictating what must be included in the end user’s manual for
the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER’S MANUAL
The following information (in blue) must be included in the end-product
user’s manual to ensure continued FCC and Industry Canada regulatory
compliance. The ID numbers must be included in the manual if the device
label is not readily accessible to the end user. The compliance paragraphs
below must be included in the user's manual.
******************************************************************************
FCC ID: LXPP006
IC: 2298A-P006
PMN: P006
This device complies with Part 15 of the FCC Rules and with ISED Canada license-
exempt RSSs. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Note: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
24 June 2020