Operating Instructions

MI2C001-001-US
Operating Instructions
© Rosenberger 2019 – www.rosenberger.com
Page 7 of 18
5 Device Description and Usage / Installation Instructions
• The MI2C001-001-US is a telematics unit that is solely intended for installation in
a GSH27 jackhammer. Therefore, please also observe the information in the
"Safety Information" section.
When installing the MI2C001-001-US component, special care must be taken to
ensure that the requirements concerning the following are met: protection against
operator contact, fire protection, and air gaps and creepage distances.
DANGER: To ensure this, it is vital to install the device in the jackhammer
grip because this has been designed as a double-insulated housing.
Any other form of installation is incorrect and protection CANNOT be ensured.
The level of protection supported by the device will also be compromised if the
device is used other than stipulated by the manufacturer.
Connecting the Device to the Power Supply:
Only authorized specialist personnel are permitted to carry out installation work. For
this, the jackhammer must be disconnected from the line voltage by pulling out the
power plug. Before installing the unit, make sure that it is safe to do so by following
the five electrical safety rules.
Install the device in the jackhammer grip as follows:
1. Remove the four screws from the cover of the jackhammer grip as marked in
Figure 1.
Figure 1: Removing the cover