User's Manual Part 1

pliance with the essential requirements and
other relevant provisions of Directive
1999/5/EC.
Electromagnetic compatibility
The electromagnetic compatibility of
the vehicle
components has been checked and certified
according to the currently valid version of Direc-
tive ECE-R 10.
Vehicle components that receive
and/or transmit radio waves
i
This devices complies with part 15 of the
FCC Rules. Operation is subject to the follow-
ing two conditions:
(1) This device may not cause harmful inter-
ference and
(2) This device must accept any interference
received, including interference that may
cause undesired operation
i
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmful interference
in a residential installation. This equipment
generates uses and can radiate radio fre-
quency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communica-
tions. However, there is no guarantee that
interference will not occur in a particular
installation.
If this equipment does cause harmful inter-
ference to radio or television reception, which
can be determined by turning the equipment
o and on, the user is encouraged to try to cor-
rect the interference by one of the following
measures:
R
Reorient or relocate the receiving antenna.
R
Increase the separation between the equip-
ment and receiver.
R
Connect the equipment into an outlet on a
circuit different from that to which receiver
is connected.
R
Consult the dealer for help.
i
RF exposure:
The equipment complies with FCC RF expo-
sure limits set forth for an uncontrolled envi-
ronment.
This equipment must be installed and oper-
ated with a separation distance of at least
20 cm from all persons
The antenna(s) used for this transmitter must
not be co-located or operating in conjunction
with any other antenna or transmitter.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
Copyright information
Registered trademarks
Bluetooth
®
technology is the standard for
short-range wireless data transmission of up to
approximately 10 metres.
Bluetooth
®
is a registered trademark of Blue-
tooth Special Interest Group (SIG) Inc.
An SD card is a digital storage medium.
SD cards carry the logo displayed above. This
logo is a registered trademark of SanDisk Cor-
poration.
6
Introduction