User's Manual

PSA RCC manual for radio type approval tests
and iPerf
internal: Manual_iPerf_and_RTA_tests_PSA_V2.docx
2016-03-15
13 / 15
Car Multimedia
EMC-Centre
7.1 Connect to WLAN-Access Point and do iPerf
In order to connect to a WLAN Access Point an unsecured WLAN network with the SSID “PSA-WLAN”
is necessary. If punitest was used directly before the device must be restarted before normal WLAN
operation is possible.
If not already done change directory with “cd /rta”. Afterwards type “./init_wifi.sh” to connect to the
WLAN network.
Now configure the IP of the DUT according the network settings of your Access Point with
“ifconfig wlan0 suitable IP”
Start “jPerf” on the PC which is connected to the Access Point.