User's Guide

JOBNAME: 1093929-2013-asd-own PAGE: 120 SESS: 4 OUTPUT: Tue Mar 27 10:39:14 2012
PROGRAMMING HOMELINKT
If you have any questions or are having difficulty
programming your HomeLinkT buttons, refer to
the HomeLinkT web site at: www.homelink.com
or call 1-800-355-3515.
NOTE:
It is also recommended that a new battery
be placed in the hand-held transmitter of
the device being programmed to
HomeLinkT for quicker programming and
accurate transmission of the radio-
frequency.
1. Position the end of your hand-held transmit-
ter 1–3 inches (5–14 cm) away from the
HomeLinkT surface, keeping the HomeLinkT
indicator light
s
1
in view.
2. Using both hands, simultaneously press and
hold the desired HomeLinkT button and
handheld transmitter button. DO NOT re-
lease until the HomeLinkT indicator light
s
1
flashes slowly and then rapidly. When the
indicator light flashes rapidly, both buttons
may be released. (The rapid flashing indi-
cates successful programming.)
NOTE:
Some devices may require you to replace
Step 2 with the cycling procedure noted in
the “Programing HomeLinkT for Canadian
customers and gate openers” section.
3. Press and hold the programmed HomeLinkT
button and observe the indicator light.
● If the indicator light
s
1
is
solid/continuous, programming is
complete and your device should acti-
vate when the HomeLinkT button is
pressed and released.
● If the indicator light
s
1
blinks rapidly for
two seconds and then turns to a
solid/continuous light, continue
with Steps 4-6 for a rolling code device.
A second person may make the following
steps easier. Use a ladder or other device.
Do not stand on your vehicle to perform
the next steps.
LIC2365 LIC2366
2-50 Instruments and controls
Z REVIEW COPY—
2013 Altima Sedan (asd)
Owners Manual—USA_English (nna)
03/24/12—dmoore
X