User's Manual
Table Of Contents
- Foreword
- Introduction
- Getting started
- Audio system
- Audio operation precautions
- Names and functions of audio control buttons
- Audio operations
- Audio settings
- CD/USB memory device care and cleaning
- Hands-Free Phone
- Information
- Navigation
- Safety information
- Navigation screen
- Map operation
- Setting destination
- Basic operations
- Free Text Search
- Setting home or work location as destination
- Finding address
- Finding points of interest
- Searching from previous destinations
- Searching from address book
- Setting city center
- Setting with NissanConnect⊃SM&/sup; Services
- Setting intersection
- Setting by phone number
- Setting from stored routes
- Setting with SiriusXM Travel Link
- Setting point on map
- Setting with latitude/longitude
- Using Door To Door Navigation
- Options before starting the route guidance
- Route guidance
- Viewing traffic information
- Storing a location/route
- Navigation settings
- General information for navigation system
- Voice recognition
- Troubleshooting guide
- Index
(213,1)
[ Edit: 2017/ 5/ 8 Model: AIVINJ-N ]
VOICE RECOGNITION
AIVINJN1-A8BC0EA8-7703-45A1-ACE6-B63B09F42786
Symptom Possible cause Possible solution
The system does not operate or fails to
interpret the command correctly.
The interior of the vehicle is too noisy. Close the windows or have the other occu-
pants be quiet.
The fan speed of the heater/air conditioner is
too fast.
Decrease the fan speed of the heater/air
conditioner.
The noise generated by driving the vehicle is
too loud.
Reduce the vehicle speed.
The voice command is spoken in a low voice. Speak the command in a louder voice.
The timing of speaking a command is too
early.
Speak the command after confirming the
following: a voice guidance is announced, a
tone sounds, and an icon on the screen
changes from gray to orange.
The command is spoken too slowly. Speak in a natural voice without pausing
between words.
The system prompts to repeat a command. Pronunciation is unclear. Speak clearly.
The command is spoken too late after the
tone.
Speak the command within 5 seconds after
confirming the following: a voice guidance is
announced, a tone sounds, and an icon on
the screen changes from gray to orange.
An improper command is spoken. Speak the command or a number that is
displayed on the screen.
Speak a command that is shown in the
command list.
The system does not correctly recognize a
number spoken.
Too many numbers are spoken at once. Place a pause between the appropriate digits
for correct recognition by the system. When
speaking a telephone number, place a pause
between area codes, dial codes, etc.
8. Troubleshooting guide
Condition:
8-25