Installation Guide

879
ASSEMBLY INSTRUCTIONS:
Note: Do not connect electricity until lamp is fully assembled.
1. Unpack all parts and remove packing materials. Place lamp base
on a level surface.
2. Align threaded tube (H) and alignment pin (G) with base (I).
3. Hold column (E) and base (I) together and carefully turn the
lamp onto its side. Slide washer (J) onto threaded tube (H).
Thread nut (K) onto threaded tube (H) and tighten with wrench
(L).
4. Adjust height of lamp by loosening turnknobs (C and D). Raise
or lower arm (B) to desired height. Tighten turnknobs (C and D)
until hand tight to secure arm in desired position.
5. Insert plug (F) into wall outlet.
6. Control power to lamp and adjust brightness by touching sensor
(A).
Note: This lamp comes with a non-replaceable LED solid-state bulb
installed.
IMPORTANT SAFETY INSTRUCTIONS:
* Do not use with an extension cord unless the plug from the lamp
can be fully inserted into the extension cord receptical.
* Switch power o and remove plug from the wall outlet before
replacing the bulb.
* Do not connect electricity until lamp is fully assembled.
* This lamp is UL rated for dry locations.
** To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners. **
PLEXUS FLOOR LAMP
ASSEMBLY INSTRUCTIONS FOR YOUR
(A)
(B)
(C)
(D)
(G)
(F)
(H)
(I)
(J)
(L)
(K)
(E)