Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
869
VIENNA WALL SCONCE
6. Set the mounting plate aside and drill small holes at the marked locations. Holes should be sized so anchors (K) t securely inside.
7. Push anchors (K) into the holes.
8. Carefully pull wires from the wall outlet box and thread them through the center hole in mounting plate (A).
9. Ax mounting plate (A) to wall outlet box with mounting screws (D) provided.
10. For additional support, thread mounting screws (L) through holes (B) and into wall anchors (K).
11. Lift the backplate (A) to the mounting plate and make the proper electrical connections noted in steps 12 through 14. A LICENSED
ELECTRICIAN IS RECOMMENDED.
12. Attach ground wire from xture (green or copper in color) to ground wire from outlet box. Fasten wires together with wire nut (J) and tightly
wrap connection with electrical tape.
13. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together with wire nut (J) and tightly
wrap connection with electrical tape.
14. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together with wire nut (J) and
tightly wrap connection with electrical tape. Gently push wire connections back into the wall outlet box.
15. Place backplate (C) over mounting plate (A). Use screws (E) to secure the backplate to the mounting surface.
16. Install two 60W max., type G16.5, candelabra base bulbs into the sockets (F).
17. Carefully slide shade (H) onto threaded tube (G).
18. Secure shade (H) to xture by threading decorative nut (I) onto threaded tube (G) until hand tight. NOTE: do not over tighten decorative nut (I) as
this could cause damage to the shade.
19. Reconnect main electrical supply at the fuse box/ circuit breaker and test the xture.
** To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. **
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(J)
(K)
(L)
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your
safety.
* It is very important that they are read
completely before beginning the installation
of your xture.
* WE STRONGLY RECOMMEND
INSTALLATION BY A LICENSED
ELECTRICIAN.
* Turn o power at switch before replacing
bulbs, making sure xture has had sucient
time to cool down.
* This xture is UL rated for dry locations.
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL
SUPPLY FROM THE MAIN FUSE BOX/
CIRCUIT BREAKER.
2. Remove all parts from carton and discard
packing materials. Place the parts on a level
surface.
3. Remove decorative nut (I) from threaded
tube (G).
4. Remove mounting plate (A) from backplate
(C) by unthreading screws (E). Set screws
(E) aside.
5. Place the mounting plate (A) against the
mounting surface so it is aligned with the
wall outlet box. Once aligned, check to make
sure that the mounting plate is level. When
proper placement has been conrmed, use
a pencil to mark the locations of the
mounting plate support holes (B) onto the
mounting surface.