Installation & Assembly
POLLY FLOOR LAMP
ASSEMBLY INSTRUCTIONS FOR YOUR
303
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***
ASSEMBLY INSTRUCTIONS:
NOTE: Do not connect electricity until lamp is fully assembled.
1. Unpack all parts and remove packing materials.
2. Pulling cord taut from below base (G) to avoid damage to cord,
thread column (F) onto the bottom of crystal globe (E).
3. Pulling cord taut from below base (G) to avoid damage to cord,
thread assembled column (F) onto base (G).
4. Remove nial (A) from harp (C). Squeeze harp (C) inward and
place into the opening of saddle (D).
5. Place shade (B) onto harp (C). Thread nial (A) back onto the
harp to secure the shade to the lamp.
6. Install one 150W Max. Type A, medium base bulb into the
socket.
7. Remove protective plastic from plug (H).
8. Insert polarized plug (H) into wall outlet.
IMPORTANT SAFETY INSTRUCTIONS:
* This lamp has a polarized plug (one blade is wider than the other)
as a feature to reduce the risk of electric
shock. This plug will t in a polarized outlet only one way. If it
does not t fully in the outlet, reverse the plug. If it still does not
t, contact a qualied electrician. Do NOT alter the plug.
* Do not use with an extension cord unless the plug from the lamp
can be fully inserted into the extension cord receptacle.
* Switch power o and remove plug from the wall outlet before
replacing the bulb.
* This lamp is UL rated for dry locations.
(A)
(B)
(C)
(D)
(F)
(E)
(G)
(H)