Installation & Assembly

ASSEMBLY INSTRUCTIONS FOR YOUR

MARTIN SIDE TABLE

395

ASSEMBLY INSTRUCTIONS:

(A)

(B)

(C)

(D)

(E)

(F)

(G)

(H)

(I)

(J)

(H)

Bottom View:

(G)

(I)

**To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners.**

CAUTION: This table is designed for up to 6 lbs. on a

single side. Do not exceed the maximum weight limit on

any one side.

1. Unpack all parts and remove packing materials. Place

parts on a level surface.

2. Please note: legs (J) are labeled with stickers that

correspond with stickers on channels (F). Slide the leg

labeled with sticker number one (1) into the top of the

channel labeled with matching sticker. Repeat with the

remaining legs.

3. Thread column (D) onto assembled base (E).

4. To secure legs in place, carefully turn table over. Use

wrench (I) to tighten set screws (H). Rotate wrench

until hand tight. Return table to upright position.

5. Slide glass (B) and washer (C) onto threaded tube (A).

6. Thread tube (A) into column (D) until hand tight.

PAGE 1
ASSEMBLY INSTRUCTIONS FOR YOUR MARTIN SIDE TABLE (A) (B) ASSEMBLY INSTRUCTIONS: CAUTION: This table is designed for up to 6 lbs. on a single side. Do not exceed the maximum weight limit on any one side. (C) 1. Unpack all parts and remove packing materials. Place parts on a level surface. (D) 2. Please note: legs (J) are labeled with stickers that correspond with stickers on channels (F). Slide the leg labeled with sticker number one (1) into the top of the channel labeled with matching sticker.