Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
3388
OCTAVIUS HALF WALL SCONCE
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/ CIRCUIT BREAKER.
2. Remove all parts from carton and discard packing materials. Place the parts on a level surface.
3. Remove shade (H) from backplate (E) by unthreading screws (I). Set screws (I) aside.
4. Remove mounting plate (A) from backplate (E) by unthreading decorative nuts (F). Set nuts (F) aside.
5. Place the mounting plate (A) against the mounting surface so it is aligned with the wall outlet box. Once aligned, check to make sure that the
mounting plate is level. When proper placement has been conrmed, use a pencil to mark the locations of the mounting plate support holes (C)
onto the mounting surface.
6. Set the mounting plate aside and drill small holes at the marked locations. Holes should be sized so anchors (K) t securely inside.
7. Push anchors (K) into the holes.
8. Carefully pull wires from the wall outlet box and thread them through the center hole in mounting plate (A).
9. Ax mounting plate (A) to wall outlet box with mounting screws (D) provided.
10. For additional support, thread mounting screws (L) through holes (C) and into wall anchors (K).
11. Lift the backplate (A) to the mounting plate and make the proper electrical connections noted in steps 12 through 14. A LICENSED
ELECTRICIAN IS RECOMMENDED.
12. Attach ground wire from xture (green or copper in color) to ground wire from outlet box. Fasten wires together with wire nut (J) and tightly
wrap connection with electrical tape.
13. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together with wire nut (J) and tightly
wrap connection with electrical tape.
14. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together with wire nut (J) and
tightly wrap connection with electrical tape. Gently push wire connections back into the wall outlet box.
15. Place backplate (E) over mounting plate (A). Use decorative nuts (F) to secure the backplate to the mounting surface.
16. Install two 60W max., type A, medium base bulbs into the sockets (G).
17. Place shade (H) onto backplate (E), aligning holes for screws. To secure shade to xture, thread screws (I) into shade (H) until hand tight.
18. Reconnect main electrical supply at the fuse box/ circuit breaker and test the xture.
** To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. **
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety.
* It is very important that they are read completely before beginning the installation of your xture.
* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
* Turn o power at switch before replacing bulbs, making sure xture has had sucient time to cool down.
* This xture is UL rated for dry locations.
(A)
(B)
(C)
(E)
(I)
(J )
(K)
(D)
(F)
(H)
(G)
(L)