Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
B169
(J)
OUTLET BOX
(A)
(B)
(C)
(D)
(E)
ILLUSTRATION A
(D)
(F)
(G)
(H)
(I)
ELENA LARGE PENDANT
SAFETY INSTRUCTIONS:
SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is important
that they are read completely before beginning installation.
*WE STRONGLY RECOMMEND INSTALLATION BY A
LICENSED ELECTRICIAN.
*Always turn off power at switch before replacing bulbs.
ASSEMBLY INSTRUCTIONS:
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE
MAIN FUSE BOX/ CIRCUIT BREAKER.
2. Remove all parts carefully from the carton. Do not throw away
any parts.
3. Remove mounting plate (B) from canopy (D) by removing
canopy screws (E). Set canopy screws (E) aside.
4. Affi x mounting plate (B) to ceiling outlet box with mounting
screws (C), provided.
5. Measure desired drop for fi xture to hang.
6. From inside canopy (D), loosen screw (G) on wire clamp (F).
Guide cord through hole in canopy (D) and slide it to the
position of desired drop. Pass cord through clamp (F) and
tighten screw (G). If necessary, cut excess cord, leaving 5 or 6
inches of length for wire connections.
7. Lift canopy (D) to ceiling outlet box; make proper
electrical connections. A LICENSED ELECTRICIAN IS
RECOMMENDED.
8. Attach ground wire from the fi xture (green or copper in color) to
the ground wire in outlet box. Fasten wires together with wire
nut (A) and tightly wrap connection with electrical tape.
9. Attach hot wire from fi xture (black in color, or smooth side of
wire) to hot wire from ceiling outlet box. Fasten wires together
with wire nut (A) and tightly wrap connection with electrical
tape.
10. Attach neutral wire from fi xture (white in color or ribbed side
of wire) to neutral wire from ceiling outlet box. Fasten wires
together with wire nut (A) and tightly wrap connection with
electrical tape.
11. Gently push wire connections back into ceiling outlet box.
Place canopy (D) fl ush against ceiling. Use canopy screws (E)
to attach the canopy to the mounting plate.
12. Insert one (1) 100W MAX. Type A, medium base
bulb into the socket.
13. Lift the shade over the bottom section of fi xture. Slide split
washer (J) between shade washer (H) and shade washer (I).
Secure the position of the shade by turning shade washer (H)
clockwise until it rests fi rmly against split washer (J).
14. Reconnect main electrical supply at fuse box/ circuit breaker
and test the fi xture.
** To clean, wipe with a soft cloth only. Do not use chemical or
abrasive cleaners as they can damage the fi nish of the lamp. **