Installation Guide

769
MEURICE FRAMED WALL SCONCE
* These instructions are provided for your safety.
* It is very important that they are read completely before beginning the installation of your xture.
* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
* Turn o power at switch before replacing bulbs, making sure xture has had sucient time to cool down.
* This xture is UL rated for dry locations.
IMPORTANT SAFETY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/ CIRCUIT BREAKER.
2. Remove all parts from carton and discard packing materials. Place the parts on a level surface.
3. Remove mounting plate (A) from backplate (D) by unthreading decorative nuts (F). Set decorative nuts (F) aside.
4. Carefully pull wires from the wall outlet box and thread them through the center hole in mounting plate (A).
5. Ax mounting plate (A) to wall outlet box with mounting screws (C) provided.
6. Lift the xture to the mounting plate and make the proper electrical connections noted in steps 7 through 9. A LICENSED ELECTRICIAN IS
RECOMMENDED.
7. Attach ground wire from xture (green or copper in color) to ground wire from outlet box. Fasten wires together with wire nut (G) and tightly
wrap connection with electrical tape.
8. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together with wire nut (G) and tightly
wrap connection with electrical tape.
9. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together with wire nut (G) and
tightly wrap connection with electrical tape. Gently push wire connections back into the wall outlet box.
10. Place backplate (D) over mounting plate (A). For sconces without shade: rethread decorative nuts (F) onto threaded tubes (B) to secure backplate
to the mounting surface. For shaded sconce: Place shade (E) over backplate (D), aligning holes in shade with threaded tubes (B). Thread
decorative nuts (F) onto threaded tubes (B) to secure shade to the backplate.
11. Install one 40W MAX. Type G, candelabra base bulbs into the socket.
12. Reconnect main electrical supply at the fuse box/ circuit breaker and test the xture.
ASSEMBLY INSTRUCTIONS:
** To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. **
ASSEMBLY INSTRUCTIONS FOR YOUR
(A)
(B)
(D)
(G)
(E)
(F)
(C)
Shade
Sold Separately
(#SHD40)