Installation Guide

764
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety.
* It is very important that they are read completely
before beginning the installation of your xture.
* WE STRONGLY RECOMMEND
INSTALLATION BY A LICENSED
ELECTRICIAN.
* Turn o power at switch before replacing bulbs,
making sure xture has had sucient time to cool
down.
* This xture is UL rated for damp locations.
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY
FROM THE MAIN FUSE BOX/ CIRCUIT
BREAKER.
2. Remove all parts from carton and discard packing
materials. Place the parts on a level surface.
3. Remove shade (F) from backplate (B) by
unthreading screws (D). Set screws and shade aside.
4. Remove mounting plate (A) from backplate (B) by
unthreading decorative nuts (E). Set decorative nuts
(E) aside.
5. Carefully pull wires from the wall outlet box and
thread them through the center hole in mounting
plate (A).
6. Ax mounting plate (A) to wall outlet box with
mounting screws (C) provided.
7. Lift backplate (B) to the mounting plate (A) and
make the proper electrical connections noted in
steps 8 through 10. A LICENSED ELECTRICIAN
IS RECOMMENDED.
** To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. **
MEURICE ELONGATED WALL SCONCE
ASSEMBLY INSTRUCTIONS FOR YOUR
(A)
(B)
(C)
(D)
(E)
(F)
(G)
8. Attach ground wire from xture (green or copper in color) to ground wire from outlet box. Fasten wires
together with wire nut (G) and tightly wrap connection with electrical tape.
9. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten
wires together with wire nut (G) and tightly wrap connection with electrical tape.
10. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box.
Fasten wires together with wire nut (G) and tightly wrap connection with electrical tape. Gently push
wire connections back into the wall outlet box.
11. Place backplate (B) over mounting plate (A). Use decorative nuts (E) to secure the backplate to the
mounting surface.
12. Place shade (F) onto backplate (B), aligning holes for screws (D). To secure shade to xture, thread
screws (D) into shade (F) until hand tight.
13. Install two 40W max., type B, medium base bulbs into the sockets.
14. Reconnect main electrical supply at the fuse box/circuit breaker and test the xture.