Installation Guide

706
ASSEMBLY INSTRUCTIONS:
1. Unpack all parts and place them on a level surface.
2. Align column (J) with column (L). Thread column (J) onto
threaded tube (K). Pull cord taught from below column (L) to
prevent damage to wire. Turn until hand tight.
3. Align column (L) with holes in center of plate (N) and base (O).
4. Place threaded tube (M) through holes in center of plate (N) and
base (O). Pull cord taught from below base (O) to prevent damage
to wire.
5. Slide washer (P) and washer (R) onto threaded tube (M). Thread
nut (S) onto threaded tube (M) and tighten with wrench (T).
6. Carefully turn lamp back into upright position.
7. Insert one (1) 60W MAX. B11 Medium base bulb into socket
located inside shade (E).
8. Remove protective plastic (U) from polarized plug (Q). Insert
polarized plug (Q) into wall outlet.
9. To adjust position of shade (E), loosen turn knobs (A) and (F).
Carefully move arms (C) and (D) into desired position. Tighten
turn knobs (A) and (F) to secure position of shade (E).
10. To adjust height of clamp (H), loosen turn knob (I). Carefully
slide clamp (H) up and down column (J), into desired position.
Tighten turn knob (I) to secure position of clamp. Repeat steps
for remaining clamp.
11. To adjust depth of clamp (H), loosen turn knob (G). Carefully
slide clamp (H) into desired position. Tighten turn knob (G) to
secure position of clamp. Repeat steps for remaining clamp.
12. Use switch (B) to control power to lamp.
*** To clean, use a soft cloth only. Do not use any chemical or
abrasive cleaners. ***
SAFETY INSTRUCTIONS:
* This lamp comes with a polarized plug as a feature to reduce the
risk of electrical shock. If the plug does not t into your outlet,
contact a licensed electrician.
* NEVER alter the plug.
* Remove plug from wall outlet before replacing light bulb.
* Do not connect the electricity until lamp is fully assembled.
ASSEMBLY INSTRUCTIONS FOR YOUR
BRISTOL EASEL FLOOR LAMP
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(J)
(K)
(L)
(M)
(N)
(O)
(P)
(Q)
(R)
(S)
(T)
(U)