Installation Guide

700

ASSEMBLY INSTRUCTIONS FOR YOUR

CLARIDGE FLOOR LAMP

ASSEMBLY INSTRUCTIONS:

Note: Do not connect electricity until lamp is fully assembled.

1. Unpack all parts and remove packing materials. Place lamp base on level

surface.

2. Thread column (E) into the top of column (F). Pull cord taut from

below column (F) to prevent damage to the wire when threading the

parts together.

3. Carefully thread base (G) onto the bottom of column (F). Pull cord taut

from below base (G) to prevent damage to the wire when threading parts

together.

4. Carefully turn lamp into upright position.

5. Remove ﬁ nial (A) from harp (C). Squeeze harp (C) inward and place

into the opening of saddle (D).

6. Place shade (B) onto harp (C). Thread ﬁ nial (A) back onto the harp to

secure the shade to the lamp.

7. Install one 150W max. Type A, medium base bulb into the socket.

8. Remove protective plastic from plug (H).

9. Insert plug (H) into wall outlet.

IMPORTANT SAFETY INSTRUCTIONS:

* This lamp has a polarized plug (one blade is wider than the other) as a

feature to reduce the risk of electric shock. This plug will ﬁ t in a polarized

outlet only one way. If it does not ﬁ t fully in the outlet, reverse the plug.

If it still does not ﬁ t, contact a qualiﬁ ed electrician. Do NOT alter the

plug.

* Do not use with an extension cord unless the plug from the lamp can be

fully inserted into the extension cord receptical.

* Switch power oﬀ and remove plug from the wall outlet before replacing

the bulb.

* Do not connect electricity until lamp is fully assembled.

* This lamp is UL rated for dry locations.

** To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners. **

(A)

(B)

(C)

(D)

(E)

(F)

(G)

(H)