Installation Guide
ASSEMBLY INSTRUCTIONS FOR YOUR
PARKER WALL SCONCE
662
ASSEMBLY INSTRUCTIONS:
Note: Turn the power off (unplug from the wall outlet) before replacing the bulb, making sure the bulb has had
sufcient time to cool down. Do not subject the xture to any shock while lit as shattering of bulb may result.
IMPORTANT SAFETY INSTRUCTIONS
*** Do not connect electricity until lamp is fully assembled. ***
1. Shut off electrical supply from main fuse box / circut breaker.
2. Unpack all parts, do not discard any parts.
3. Align backplate (A) and outlet box, and make proper electrical
connection.
4. Connect the copper wire from xture to ground (green) wire from
the outlet box. Connect white or rough side of wire from xture
to white wire from outlet box using wire nuts (F). Connect black
or smooth side of wire from xture to black wire from outlet box
using wire nuts (F).
5. Afx mounting plate (A) to the wall using mounting plate screws
(E) provided.
6. Insert one (1) Type B, 60 watt max. bulb into socket (G).
7. Carefully align holes in glass shade (H) with shade support arms
(D). Insert threaded ends of shade support arms (B) through holes
in glass shade (H) into threaded ends of shade support arms (D).
8. Remove threaded nuts (C) from shade support arms (B) and set
aside. Caution, make sure not to unthread shade support arms (B)
when removing threaded nuts (C).
9. Carefully place metal shade (I) over glass shade (H). Align holes
in metal shade (I) with shade support arms (B). Thread nuts (C)
into ends of shade support arms (B) securing metal shade (I) to
the xture.
Caution: To clean, use a soft cloth only. Do not use any chemical or
abrasive cleaners.
*These instructions are provided for your safety. It is very important that they are read completely before
beginning the installation of your xture.
*For direct wire xtures, we strongly recommend installation by a licensed electrician.