Installation Guide

537
ASSEMBLY INSTRUCTIONS FOR YOUR
BOND OUTDOOR PENDANT
(A)
(B)
(D)
(E)
(F)
(G)
(H)
(I)
(C)
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety.
* It is very important that they are read completely before beginning the
installation of your xture.
* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED
ELECTRICIAN.
* Turn o power at switch before replacing bulbs, making sure xture has had
sucient time to cool down.
* This xture is UL rated for wet locations.
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE
BOX/ CIRCUIT BREAKER.
2. Remove all parts carefully from the carton. Do not throw away any parts.
3. Remove mounting plate (A) from canopy (D) by removing canopy screws (C).
Set canopy screws (C) aside.
4. Carefully pull the wiring from the ceiling outlet box. Thread the wires through
the center hole in mounting plate (A).
5. Ax mounting plate (A) to ceiling outlet box with mounting screws (B),
provided.
6. Measure desired drop for xture to hang and add/remove chain links (G) with
chain break tool (not included).
7. Secure quick link (F) to hang straight (E).
8. Guide wire exiting the xture through chain (G), quick link (F), through the
center of the hang straight (E), and up through the hole in the canopy (D).
9. Cut the cord to the desired length to make electrical connections. Note: At least 8
inches of wire is needed to make proper electrical connections.
10. Lift canopy (D) to mounting plate (A) and make proper electrical connections
described in steps 11-13. A LICENSED ELECTRICIAN IS RECOMMENDED.
11. Attach ground wire from the xture (green or copper in color) to the ground wire
in outlet box. Fasten wires together with wire nut (I) and tightly wrap connection
with electical tape.
12. Attach hot wire from xture (black in color, or smooth side of wire) to hot wire
from ceiling outlet box. Fasten wires together with wire nut (I) and tightly wrap
connection with electrical tape.
13. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral
wire from ceiling outlet box. Fasten wires together with wire nut (I) and tightly
wrap connection with electrical tape.
14. Gently push wire conections back into ceiling outlet box. Slide canopy (D) over
mounting plate (A). Thread screws (C) into holes in canopy (D) to secure xture
to ceiling.
15. Install three 100W MAX. Type A, medium base bulb into socket (H).
16. Reconnect main electrical suppy from the fuse box/ circuit breaker and
test the xture.
** To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. **