Installation Guide

556
ASSEMBLY INSTRUCTIONS FOR YOUR
BOND OUTDOOR SCONCE
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY
FROM THE MAIN FUSE BOX/ CIRCUIT
BREAKER.
2. Remove all parts carefully from the carton. Do not
throw away any parts.
3. Remove mounting plate (A) from backplate (D) by
unthreading screws (E). Set screws (E) aside.
(J )
(K)
(L)
(B)
(A)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
4. Place the mounting plate (A) against the mounting surface so it is aligned
with the wall outlet box. Once aligned, check to make sure that the
mounting plate is level. When proper placement has been conrmed, use a
pencil to mark the locations of the mounting plate support holes (B) onto the
mounting surface.
5. Set the mounting plate aside and drill small holes at the marked locations.
Holes should be sized so anchors (K) t securely inside.
6. Push anchors (K) into the holes.
7. Carefully pull wires from the wall outlet box and thread them through the center
hole in mounting plate (A).
8. Ax mounting plate (A) to wall outlet box with mounting screws (C) provided.
9. For additional support, thread mounting screws (L) through support holes (B) and into wall anchors (K).
10. Lift the backplate (D) to the mounting plate and make the proper electrical connections noted in steps 11 through 13. A
LICENSED ELECTRICIAN IS RECOMMENDED.
11. Attach ground wire from xture (green or copper in color) to ground wire from outlet box. Fasten wires together with
wire nut (J) and tightly wrap connection with electrical tape.
12. Attache hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together
with wire nut (J) and trightly wrap connection with electrical tape.
13. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires
together with wire nut (J) and tightly wrap connection with electrical tape. Gently push wire connections back into the
wall outlet box.
14. Place backplate (D) over mounting plate (A). Use screws (E) to secure the backplate to the mounting surface.
15. Install one 100W max., type A, medium base bulb into the socket (H).
16. Remove screws (G) and set them aside. Lift shade (I) to canopy (F) and align holes. Thread screws (G) back into
canopy (F) to secure shade. Turn until hand tight.
17. Reconnect main electrical supply at the fuse box/ circuit breaker and test the xture.
** To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. **
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety.
* It is very important that they are read completely
before beginning the installation of your xture.
* WE STRONGLY RECOMMEND
INSTALLATION BY A LICENSED
ELECTRICIAN.
* Turn o power at switch before replacing bulbs,
making sure xture has had sucient time to cool
down.
* This xture is UL rated for wet locations.