Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
WONTON
WALL SWINGER
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE
MAIN FUSE BOX/CIRCUIT BREAKER.
2. Remove the mounting plate (G) from the base of the lighting xture (I) by remov-
ing the base screws (F).
3. Cut the polarized plug from the end of electric cord and remove the cord cover (if
attached).
4. From the backside of the lamp, pull the electric cord up through the exit hole at the
bottom of the backplate.
5. Take the screw plug (J) and attach to the base (I) into the hole vacated by the cord.
6. Gently pull the wiring from the wall outlet box and allow the wires to hang. Thread
the wires through the center hole in the mounting plate (G).
7. Afx the mounting plate (G) to the wall outlet box with the mounting plate screws
(H) provided.
8. Connect the copper wire from xture to ground.
9. Connect rough side of wire from xture to white wire.
10. Connect smooth side of wire from xture to black wire.
11. Attach xture (I) to the mounting plate (G). Secure xture (I) to the mounting plate
(G) with base screws (F).
12. Follow steps 5 - 7 in cord cover assembly instructions above for completion of
assembly .
1. Remove the mounting plate (G) from the base of the
lighting xture (I) by removing the base screws (F).
2. Afx the mounting plate (G) to the wall with the
mounting plate screws (H) provided.
3. Attach xture (I) to the mounting plate (G) and secure with
screws (F).
4. Attach cord cover (E) to bottom of light base (I) by
turning (E) in counter-clockwise direction.
5. Put harp (C) into harp saddle cup (D) by squeezing both
sides of the harp inward and afxing to the top section of
(D).
6. Remove the nial (A) from harp (C) and attach shade (B)
to harp (C). Secure shade (B) to harp (C) with nial (A).
7. Insert light bulb Type A, maximum 100 watts into socket.
8. Plug lamp cord into wall outlet.
DIRECT WIRE ASSEMBLY INSTRUCTIONS
CORD COVER
ASSEMBLY INSTRUCTIONS
4237













