Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
383
(A)
(B)
(C)
(D)
(G)
(E)
(F)
(H)
(I)
(J)
(K)
(L)
EDWARD PENDANT
SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is important that they are read
completely before beginning installation.
*WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED
ELECTRICIAN.
*Always turn o power at switch before replacing bulbs.
*This xture is UL rated for dry locations.
*DUE TO THE WEIGHT OF THIS ITEM, YOUR CEILING OUTLET BOX MUST
BE RATED FOR FIXTURES UP TO 150 LBS. FOLLOW MANUFACTURERS
INSTRUCTIONS FOR CEILING OUTLET BOX INSTALLATION.
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/
CIRCUIT BREAKER.
2. Remove all parts carefully from the carton. Do not throw away any parts. Please
Note: diuser (K) is located in styrofoam at the bottom of the package. Do not
disregard or throw away.
3. Remove mounting plate (B) from canopy (D) by removing canopy screws (E). Set
canopy screws (E) aside.
4. Carefully pull the wiring from the ceiling outlet box. Thread the wires through the
center hole in mounting plate (B).
5. Ax mounting plate (B) to ceiling outlet box with mounting screws (C), provided.
6. Measure desired drop for xture to hang and add/remove chain links (H) with chain
break tool (not included).
7. Secure quick link (G) to hang straight (F). Repeat this step for remaining chains.
8. Guide wire exiting the xture through chain (H), quick link (G), through the center
of the hang straight (F), and up through the hole in the canopy (D).
9. Cut the cord to the desired length to make electrical connections. Note: At least 8
inches of wire is needed to make proper electrical connections.
10. Lift canopy (D) to mounting plate (B) and make proper electrical connections
described in steps 11-13. A LICENSED ELECTRICIAN IS RECOMMENDED.
11. Attach ground wire from the xture (green or copper in color) to the ground wire in
outlet box. Fasten wires together with wire nut (A) and tightly wrap connection
with electical tape.
12. Attach hot wire from xture (black in color, or smooth side of wire) to hot wire
from ceiling outlet box. Fasten wires together with wire nut (A) and tightly wrap
connection with electrical tape.
13. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral
wire from ceiling outlet box. Fasten wires together with wire nut (A) and tightly
wrap connection with electrical tape.
14. Gently push wire conections back into ceiling outlet box. Slide canopy (D) over
mounting plate (B). Thread screws (E) into holes in canopy (D) to secure xture to
ceiling.
15. Lift xture to an approriate height in order to attach chains (H) to xture. Secure
quick link (I) to loop (J). Repeat for remaining chains.
16. Install three 60W MAX. Type A, medium base bulbs into sockets located inside the
shade.
17. Remove nial (L) from the tube below sockets.
18. Place glass diuser (K) over the threaded tube below the sockets. Thread nial (L)
back onto threaded tube to secure position of diuser. Note: Do not over tighten
nial (L) as it can cause glass diuser (K) to break.
19. Reconnect main electrical supply at the fuse box/circuit breaker and test xture.
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***