Installation Guide
ASSEMBLY INSTRUCTIONS FOR YOUR
CEDRIC FLOOR LAMP
387
ASSEMBLY INSTRUCTIONS:
IMPORTANT SAFETY INSTRUCTIONS:
* This lamp has a polarized plug (one blade is wider than the
other) as a feature to reduce the risk of electric shock. This
plug will t in a polarized outlet only one way. If it does not
t fully in the outlet, reverse the plug. If it still does not t,
contact a qualied electrician. Do NOT alter the plug.
* Do not use with an extension cord unless the plug from the
lamp can be fully inserted into the extension cord receptacle.
* Switch power o and remove plug from the wall outlet
before replacing the bulb.
* This lamp is UL rated for dry locations.
NOTE: Do not connect electricity until lamp is fully assembled.
1. Unpack all parts and remove packing materials. Place
lamp base on level surface.
2. Unthread screw (H) from the shade riser (E).
3. Insert screw (H) through the bottom side of the opening in bracket
(G). read shade riser (E) onto shade riser nut (H).
4. Remove nial (A) and shade lock (B) from shade
riser (E).
5. Place shade (D) onto shade riser (E). Place shade
lock (B) over shade washer (C). Thread nial (A) back
onto the shade riser to secure the shade to the lamp.
6. Install two 60W max. Type B, candelabra base bulbs
into the sockets (F).
7. Remove plastic cover from plug (I).
8. Insert plug (I) into wall outlet.
**To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners. **
(F)
(E)
(H)
(A)
(B)
(C)
(D)
(G)
(I)