Installation Guide

WILLIAMSBURG CORONET CHANDELIER
ASSEMBLY INSTRUCTIONS FOR YOUR
* These instructions are provided for your safety.
* It is very important that they are read completely before beginning the
installation of your xture.
* If any special control devices are used with this xture, follow the instructions
carefully to assure full compliance with N.E.C. requirements. If there are any
questions, contact a qualied electrical contractor.
* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED
ELECTRICIAN.
* Turn o power at switch before replacing bulbs, making sure xture has had
sucient time to cool down.
* This xture is UL rated for dry locations.
* Due to the weight of this item, your ceiling outlet box must be rated for xtures
up to 100 lbs. Follow manufacturer’s instructions for ceiling outlet box
installation.
** To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners. **
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT FUSE BOX/ CIRCUIT
BREAKER.
2. Remove all parts from carton. Do not throw away any parts.
3. Remove cross bar (A) (with threaded tube (C) and hang straight (F) attached)
from canopy (D). Do this by unthreading collar (E) from hang straight (F).
Canopy (D) will slip over hang straight (F). Set the canopy (D) and collar (E)
aside.
4. Ax cross bar (A) (with threaded tube (C) and hang straight (F) attached) to
ceiling outlet box using mounting screws (B) provided.
5. Measure the desired drop for the xture to hang from ceiling. If necessary,
remove links from chain (H) with chain break tool (not included) to achieve the
desired drop.
6. Thread chain (H) through the center of collar (E). Move the collar down the
length of the chain so it rests on loop (I). Thread chain (H) through the center of
canopy (D). Move the canopy down the length of the chain so it rests on collar
(E).
7. Lift xture to the ceiling outlet box and secure quick link (G) to hang striaght
(F).
8. Guide the wires exiting xture through the center of collar (E) and canopy (D).
Continue to guide the wires through the links of chain (H), through the center of
hang straight (F) and up through the center of threaded tube (C).
9. Cut the cord to the desired length to make electrical connections. Note: at least 8
inches of wire will be needed for proper connections. Make proper electrical
connections described in steps 10-12. A LICENSED ELECTRICIAN IS
RECOMMENDED.
10. Attach ground wire from xture (green or silver in color) to ground wire from outlet
box. Fasten wires together with wire nut (K) and tightly wrap connection with
electrical tape.
11. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from
outlet box. Fasten wires together with wire nut (K) and tightly wrap connection with
electrical tape.
12. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral
wire from outlet box. Fasten wires together with wire nut (K) and tightly wrap
connection with electrical tape.
13. Carefully push wire connections back into ceiling outlet box.
14. Slide canopy (D) up chain (H) and hold ush against ceiling. To secure position of
canopy (D), slide collar (E) up the chain and thread it onto hang straight (F). Turn
until hand tight.
15. Install ten 40W max. Type B, candelabra base bulbs into the sockets (J).
16. Reconnect main electrical supply from the fuse box/ circuit breaker and test the
xture.
IMPORTANT SAFETY INSTRUCTIONS:
ASSEMBLY INSTRUCTIONS:
367
(A)
(B)
(C)
(D)
(E)
(F)
(I)
(H)
(G)
(K)
(J)