Installation Guide

306

ASSEMBLY INSTRUCTIONS:

1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/ CIRCUIT BREAKER.

2. Remove all parts from carton, and remove all packing material. Do not throw away any parts.

3. Set ﬁ xture on a level surface so shade (H) is facing up. Remove shade from ﬁ xture by rotating metal frame (H) counterclockwise

and lifting it straight up. Tabs (G) will slide off of metal pins inside canopy D so the parts can be seperated. Set shade (H) aside.

4. Remove cross bar (A) from canopy (D) by removing nuts (E). Set nuts (E) aside.

5. Attach cross bar (A) (with screws (B) attached) to ceiling outlet box using screws (C), provided.

6. Lift canopy (D) to cross bar (B) and guide wiring from canopy (D) through center hole in cross bar (A). Make proper electrical

connections as described in steps 7 - 9. A LICENSED ELECTRICIAN IS RECOMMENDED.

7. Attach ground wire from ﬁ xture (GREEN in color) to ground wire in outlet box (usually GREEN or COPPER in color). IT IS

IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

8. Connect the neutral wire from ﬁ xture (WHITE in color or RIBBED side of wire) to the neutral wire from the outlet box. Fasten

wires together using wire nut (I) and tightly wrap connection with electrical tape.

9. Connect the hot wire from ﬁ xture (BLACK in color or SMOOTH side of wire) to the hot wire from the outlet box. Fasten wires

together using wire nut (I) and tightly wrap connection with electrical tape. Carefully push wires back into the ceiling outlet box.

10. Align holes in canopy (D) with screws (B) on crossbar (A). Lift canopy (D) to crossbar (A) so screws (B) protrude through holes

in the canopy. Attach nuts (E) to the exposed threading on screws (B) to secure the canopy to the crossbar.

11. Insert two 40W MAX Type B, medium base bulbs into the sockets.

12. Carefully place glass ring (F) inside shade (H). Lift the shade to canopy (D). Slide metal frame (H) into canopy (D). Carefully

rotate shade frame (H) clockwise until tabs (G) slip over the pins in canopy (D) and the shade is securely attached in place.

* To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. *

*These instructions are provided for your safety. It’s important that they’re read completely before beginning installation of ﬁ xture.

*WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.

*Turn off power at switch before replacing bulbs, making sure ﬁ xture has had sufﬁ cient time to cool down.

*If any special control devices are used with this ﬁ xture, follow the instructions carefully to assure full compliance with N.E.C.

requirements. If there are any questions, contact a qualiﬁ ed electrical contractor.

IMPORTANT SAFETY INSTRUCTIONS:

(F)

(H)

(G)

OUTLET BOX

(A)

(E)

(B)

(C)

(I)

ASSEMBLY INSTRUCTIONS FOR YOUR

WILLIAMSBURG TUCKER SMALL FLUSH MOUNT