Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
BUSTER
PENDANT
2055
ASSEMBLY INSTRUCTIONS:
1) SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE
MAIN FUSE BOX/CIRCUIT BREAKER.
2) Thread top nipple of pole (F) to bottom of pole (E).
3) Thread top nipple of pole (G) to bottom of pole (F).
4) Connect the hot wires from the xture (ROUND) to the hot junc-
tion box wire from the outlet box (usually BLACK). Fasten them
together with a plastic wire connector probided and wrap connection
with electrical tape.
5) Repeat this procedure for the RIBBED neutral wires from the
light xture to the wire from the outlet box (usually WHITE).
6) Connect the ground wire from the light xture (bare copper) to the
ground wire from the outlet box.
7) Attach the mounting plate (B) to the outlet box and tighten it with
screws provided (C).
8) Replace the canopy (A) to the mounting plate (B), tighten it with
base screws (D).
9) Remove ange (M) from socket (H).
10) Put plastic washer (J) onto socket (H), letting socket (H) pass
through the hole of plastic washer (J).
11) Put glass shade (K) onto top of socket (H), and attach plastic
washer (L) to socket which protrudes into glass shade (K).
12) Tighten the shade by screwing ange (M) onto the thread of
socket (H).
13) Insert light bulb Type A, maximum 200 watt into socket.
(B)
(C)
(D)
(A)
(E)
(F)
(G)
(H)
(J)
(K)
(L)
(M)
**IT IS RECOMMENDED THAT A CERTIFIED
LICENSED ELECTRICIAN INSTALL THIS FIXTURE**