Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
ZOLTAR PENDANT
2433
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT FUSE BOX/ CIRCUIT
BREAKER.
2. Remove all parts from carton. Do not throw away any parts.
3. Remove quick link (G) from hang straight (F). Keep quick link (G) attached to
loop (H).
4. Remove cross bar (A) (with threaded nipple (C) and hang straight (F) attached)
from canopy (D) by unscrewing collar (E). Set collar (E) and canpoy (D) aside.
Afx cross bar (A) to ceiling outlet box using screws (B) provided.
5. Measure desired drop for xture to hang and add/remove extension tubes (I) to
reach desired position. Guide wiring through extension tubes before
threading tubes together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the threaded nipple of one
extension out of/ into the threaded opening of the next extension. Make sure
wiring is pulled tight when threading extensions together to prevent damage
to the wire.**
6. Thread bottom extension tube (I) onto threaded nipple (J).
7. Carefully slide threaded collar (E) and canopy (D) down extensions (I) until
they rest on shade housing (K).
8. Lift xture to ceiling and secure quick link (G) to hang straight (F). Carefully
guide wire through hang straight (F) and threaded nipple (C) into ceiling outlet box.
9. Make proper electrical connections noted in steps 10-12. A LICENSED
ELECTRICIAN IS RECOMMENDED.
10. Attach ground wire from xture (green or silver in color) to ground wire from
outlet box. Fasten wires together with wire nut (N). Tightly wrap connection with
electrical tape.
11. Attach hot wire from xture (black in color or smooth side of wire) to hot wire
from outlet box. Fasten wires together with wire nut (N) and tightly wrap
connection with electrical tape.
12. Attach neutral wire from xture (white in color or ribbed side of wire) to
neutral wire from outlet box. Fasten wires together with wire nut (N) and
tightly wrap connection with electrical tape.
13. Gently push wires back into ceiling outlet box.
14. Slide canopy (D) up extensions (I) and hold ush against ceiling. To secure
position of canopy (D), slide collar (E) up extensions (I) and thread onto hang
straight (F). Turn until hand tight.
15. Install six 25W max., type B, candelabra base bulbs into sockets (M).
16. Unthread three set screws (L), from shade housing (K).
17. Insert glass shade (N) into shade housing (K) and carefully tighten set screws
(L) until shade is secure. NOTE: Do not over tighten screws (L), as doing so could
break the glass shade (N).
18. Reconnect main electrical supply at fuse box/ circuit breaker and test the xture.
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***
*These instructions are provided for your safety. It is very important that they are
read completely before beginning the installation of your xture.
*WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED
ELECTRICIAN.
*Turn off power at switch before replacing bulbs
*If any special control devices are used with this xture, follow the instructions
carefully to assure full compliance with N.E.C. requirements. If there are any
questions, contact a qualied electrical contractor.
IMPORTANT SAFETY INSTRUCTIONS:
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(I)
(I)
(I)
(M)
(N)
(J)
(K)
(L)
(N)