Installation Guide
ASSEMBLY INSTRUCTIONS FOR YOUR
EMPIRE FLOOR LAMP
227
ASSEMBLY INSTRUCTIONS:
NOTE: Do not connect electricity until lamp is fully
assembled.
1. Unpack all parts and remove packing materials. Place lamp
base on a level surface.
2. Align column (E) with base (F). Pull cord taut from
below base to prevent damage to the wire.
3. Hold column (E) and base (F) together and carefully turn the
lamp onto its side. Slide washer (G) onto threaded tube.
Thread nut (H) onto threaded tube and tighten with wrench
(J).
4. Carefully turn lamp into upright position.
5. Remove nial (A) from harp (C). Squeeze harp (C) inward
and place into the opening of saddle (D).
6. Place shade (B) onto harp (C). Thread nial (A) back onto
the harp to secure the shade to the lamp.
7. Install one 150W max., type A, medium base bulb into the
socket.
8. Remove protective plastic from plug (I).
9. Insert plug (I) into wall outlet.
**To clean, use a soft cloth only. Do not use any chemical or
abrasive cleaners.**
IMPORTANT SAFETY INSTRUCTIONS:
* This lamp has a polarized plug (one blade is wider than the
other) as a feature to reduce the risk of electric shock. This
plug will t in a polarized outlet only one way. If it does not
t fully in the outlet, reverse the plug. If it still does not t,
contact a qualied electrician. Do NOT alter the plug.
* Do not use with an extension cord unless the plug from the
lamp can be fully inserted into the extension cord receptacle.
* Switch power o and remove plug from the wall outlet
before replacing the bulb.
* This lamp is UL rated for dry locations.
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(J)